Radar Motion Sensor Solar LED Flood Lights / Outdoor Aluminum Wall Light

Radar Motion Sensor Solar Powered Led Flood Lights Outdoor Aluminum Wall Light

Specification:

• Product Name: Aluminum triangle Solar Lights
• Solar panels Specifications: 5.5V 3.2W
• Battery: Lithium iron phosphate battery 3.2V 3000mah battery with charge and discharge protection board
• Battery protection voltage: 2.65-3.75V
• Battery Life: 2000 times charge cycles
• LED quantity: 30 lumens 0.5 watt LED * 48 pcs
• Luminous flux: 800lm luminous flux up to full power
• Housing material: PC + UV UV component
• Sensing modes: Microwave sensor
• Microwave power: 10.8G 2 mW
• Sensing distance: 5-10 meters
• Lighting modes: light control + strong lights when people nearby, micro-light when people leave,
• Mode Delay time: 15 seconds
• Lighting duration: can induction more than 500 times when full charged (15 seconds each)
• Charging time: 8 hours full sun off
• Waterproof grade: IP65

• weight:630g

• size:230*103*83mm

Product performance:

★ During the daytime, the system is charging,and the light is turned off,at night,the system starts lighting automatically
★ Each press of a button will replace a light mode,switch circularly

• power on:press and hold the button for 5-10 seconds to start the first mode.
• body sensor+micro-mode:when someone comes,the light will strong,when no one comes,the light will be bright slightly.
• human body induction mode:when someone comes,the light will strong,when no one comes, the light will turn off
• always light mode:it will always light at night,no induction function
• emergency light mode:it will be strong light for 30 minutes,and then turn off the light,the solar panel will time again after sensing the light.

★ It will work according to the installed mode every day, not need to switch again.
★ The delay time for a strong light is 15 seconds when someone is nearby,when in the induction area,the light is always bright, and when the person leaves the induction area for 15 seconds,the light enters into the power saving mode

How to use:

Power on:press and hold the switch for 5-10 seconds to enter the first mode.

Each press on button would change a light mode,switch circularly.

1.Body sensor+micro-mode:dim, full bright for 15 seconds when motion detected.

2.Human body induction mode:off, full bright for 15 seconds when motion detected.

3.Always light mode:it will always light at night,no induction function.

4.Emergency light mode:manual,full bright for 30 minutes.

5.Turn off.

Applications:

1. Mainly used for road, parking lot, stores, roof, expressway, subway, building.

2. Road toll booth decoration lighting, garden lighting and square,.

3. at the same time can also be used in street lamps, suitable for tunnel lighting.

And so on.

Color Temperature:

Details: